ronaldtrotter wrote:Just to be sure this is for aluminum A arms only?
ChuckS wrote:Brian:
The rules state:
Q. All 944/924/968 cars with aluminum A arms should have the ball joint
inspected before each event. In addition, the dimension between the wheel
center and the lowest portion of the top fender edge shall be greater than 13.0
inches. If an entrant wishes to lower the car below this, Fabcar or equivalent A
arms shall be fitted. The Event Chairperson may waive this requirement for
parking lot courses.
So, the event chair CAN waive the requirement for events at Qualcomm. The real important issue is the safety of the driver and the other drivers and cornerworkers at the event. So, we have taken the approach to deal with this exeption on a case by case basis. If the car in question is well set up and appears safe, then there should not be a problem as the stresses in a parking lot event such as ours is much less than on a track. If you have questions, please do not hesitate to give me a call on my cell at 858-449-1502 or PM me.
Users browsing this forum: No registered users and 15 guests